|
|
|
|
| |
 |
Home > >About us >> Emergency Training |
| |
Emergency Training For Maintenance Personnel | |
| |
 No response when inserting the Smart card into the Smart card lock. |
Solutions:Remove old batteries for 3 minutes and change with new batteries.Insert th Se-
tting Card and Time Card again. if the green light is on,this lock works in good order dism-
antle this lock and changethe chip ----24 C 16 (Pay attention to the word Trend the Reset card,Setting Card and Time Card again,if the red light is still on ,you should are chang ?and there is still no response,you should check whether the electrical is whole PCB.) |
| Sketch Map of PCB for IC card |
| Sketch Map of PCB for proxy card |
Illustration: 24C16---Store different reset card code and open records of each hotel, others
PCB of one hotel will be used in another hotel,you should only change this IC.Other IC are
all the same .When will not be damaged. |
When the proxy card lock is opened normally for the first time, after some time,
there is no response for this lock. |
Solutions:Repeat the above-mentioned step for changing the batteries of the Smart card
sticker on the indicator.if the sticker is shed or split,please pull it upright and fire it dry to
to the right sketch map:(PCB back of proxy card lock) lock, please focus on the make it |
Remark: The change of whole PCB is rated 10% of the whole maintenance. it is no problem
occurs. if the rate is more than 10% ,may be there is something wrong with or you should
shold consider providing further training for you mainten - ance personnel. need to change
the whole PCB when never any , the batch of goods. |
| The requirement for successful lock installation: |
when lock installation finish,it must meet the following requirements.
 The electrical wire cannot be pressed by screws or plates in case of short circuit
After inserting the card, turn the handle slightly.if you could feel much resistance,it means that the door hole for this lock does not meet requirement.Please fix the hole in time otherwise the whole lock would be damaged after some time. if the resistance is not so large,you can adjust the electronic lock`s oblique in order to lower the resistance .if you can turn the handle slightly,it means that this lock installation meets requirement. |
After the installation is up to grade, use the hammer to enlarge the bend of plate along
the door`s oblique in order to ensure the normal use for years.
(plate ) Enlarge this bend.
|
|
|
|
|
